Depending on the year of your machine, the FANUC interface may look slightly different, but finding the communication settings for the embedded port is almost always as follows: You will now have to navigate to the embedded port communication settings page.

The CNC Screen Display button will open the interface for the FANUC backend. When you click the chevrons, a screen with several options will appear. To access the FOCAS settings, press the two chevrons in the upper right corner of the control screen: Next, locate the Embedded port communication settings for sharing FOCAS data. Router settings are located in the 'Tool Box' icon. If your network drop is plugged into the NAT router, you may need to install a patch cable between the CD38A port on the FANUC NCU to the NAT router, and configure the router to acknowledge the FANUC embedded port (CD38A). Note: Keep in mind this port may be located behind the HMI in the control cabinet. If you see this unit with the ethernet port, there is a good chance your machine is equipped with FANUC FOCAS! The FANUC NCU has the embedded ethernet port from which data is shared.

Follow the steps in this article to configure your machine to share data with MachineMetrics through FOCAS.Ī good first step to take to determine whether your machine has FANUC FOCAS is to open the main electrical cabinet, and look for the FANUC NCU (Numerical Control Unit) - this will be a yellow & grey box, similar to the FANUC power supply and servo drives: The Makino Pro 6 control is most likely equipped with the data sharing protocol FANUC FOCAS.

Fanuc cnc screen display function